// Boot loader. // // Part of the boot sector, along with bootasm.S, which calls bootmain(). // bootasm.S has put the processor into protected 32-bit mode. // bootmain() loads an ELF kernel image from the disk starting at // sector 1 and then jumps to the kernel entry routine. #include "types.h" #include "elf.h" #include "x86.h" #define SECTSIZE 512 void readseg(uchar*, uint, uint); void bootmain(void) { struct elfhdr *elf; struct proghdr *ph, *eph; void (*entry)(void); uchar* va; elf = (struct elfhdr*)0x10000; // scratch space // Read 1st page off disk readseg((uchar*)elf, 4096, 0); // Is this an ELF executable? if(elf->magic != ELF_MAGIC) return; // let bootasm.S handle error // Load each program segment (ignores ph flags). ph = (struct proghdr*)((uchar*)elf + elf->phoff); eph = ph + elf->phnum; for(; ph < eph; ph++) { va = (uchar*)ph->va; readseg(va, ph->filesz, ph->offset); if(ph->memsz > ph->filesz) stosb(va + ph->filesz, 0, ph->memsz - ph->filesz); } // Call the entry point from the ELF header. // Does not return! entry = (void(*)(void))(elf->entry); entry(); } void waitdisk(void) { // Wait for disk ready. while((inb(0x1F7) & 0xC0) != 0x40) ; } // Read a single sector at offset into dst. void readsect(void *dst, uint offset) { // Issue command. waitdisk(); outb(0x1F2, 1); // count = 1 outb(0x1F3, offset); outb(0x1F4, offset >> 8); outb(0x1F5, offset >> 16); outb(0x1F6, (offset >> 24) | 0xE0); outb(0x1F7, 0x20); // cmd 0x20 - read sectors // Read data. waitdisk(); insl(0x1F0, dst, SECTSIZE/4); } // Read 'count' bytes at 'offset' from kernel into virtual address 'va'. // Might copy more than asked. void readseg(uchar* va, uint count, uint offset) { uchar* eva; eva = va + count; // Round down to sector boundary. va -= offset % SECTSIZE; // Translate from bytes to sectors; kernel starts at sector 1. offset = (offset / SECTSIZE) + 1; // If this is too slow, we could read lots of sectors at a time. // We'd write more to memory than asked, but it doesn't matter -- // we load in increasing order. for(; va < eva; va += SECTSIZE, offset++) readsect(va, offset); }